104 Solving Problems
Solving Problems With the Remote
Control
The projector doesn’t respond to remote control commands.
■ Point the remote control towards the projector’s receiver. Make
sure you are within 6 meters of the projector and within a 30°
horizontal angle and a 15° vertical angle from the projector’s front
or back receiver.
■ The remote control’s batteries may not be installed correctly or
may be low on power. To change the batteries, see page 90.
■ Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector’s infrared
receivers. Also, turn off any nearby equipment that emits infrared
energy, such as a radiant room heater.
■ If any buttons are held for longer than 30 seconds, the remote
enters sleep mode. Release any button that is held to wake the
remote.
To Next Page
Loading...
Need help?
General