Maintaining the Projector 89
7. Replace the lamp cover, then tighten its screw.
8. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu system.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Select the
Reset menu and press Enter. You see this screen:
3. Select
Reset Lamp Hours and press Enter.
4. When you see the prompt, select
Yes and press Enter.
5. When you’re finished, press
Menu to exit.
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.
To Next Page
Loading...
Need help?
General