Epson PowerLite S10+ User Manual

Fine-Tuning the Projector 69
Restoring the Default Settings
You can use the Reset option on any menu to restore the
factory-default settings for the settings in that menu.
To restore all the projector settings to their factory-default values,
select the
Reset menu, highlight Reset All, press Enter, and select
Yes to confirm.
Adjusting the Image
You can use the Image menu to adjust the brightness, sharpness, color,
tint, contrast, and Auto Iris settings.
1. Press the
Menu button on the projector or remote control and
select the
Image menu. You see a screen similar to one of these:
note
When you select Reset All
in the Reset menu, it does
not reset the Input Signal,
User’s Logo, Language, or
Lamp Hours settings.
note
If you are using the HDMI
port (PowerLite X10+/
PowerLite W10+ only), you
see the menu on the left if
the signal is digital RGB
video, or the menu on the
right if the signal is
component video.
Component video/ Composite video/
S-Video
* PowerLite X10+/PowerLite W10+ only
Computer/USB display/ RGB video/
USB
*

Epson PowerLite S10+ Specifications

General

Contrast Ratio	2000:1
Lamp Life	4000 hours (Normal Mode), 5000 hours (Eco Mode)
Display Technology	3LCD
Noise Level	37 dB (Normal Mode), 29 dB (Eco Mode)
Lamp Type	UHE
Keystone Correction	Vertical ±30 degrees
Input Ports	VGA, S-Video, Composite Video
Output Ports	VGA
Projection Size	30 - 300 inches