76 Fine-Tuning the Projector
Direct Power On: Enable if you want to be able to start the
projector when you connect the power cord (without pressing the
Ppower button).
Sleep Mode: Enable if you want the projector to turn off
automatically if it is idle and no signal is received for 1 to 30
minutes (you can adjust the amount of time using the next
setting).
Sleep Mode Timer: When Sleep Mode is on, you can set the
period of time before the projector turns off automatically, from
1to 30 minutes.
Lens Cover Timer: Enabled by default to turn the projector’s
power off automatically when the
A/V Mute slide is closed for
more than 30 minutes.
High Altitude Mode: Enable when you are using the projector
above 4,921 feet (1,500 meters) to ensure that the temperature is
regulated properly. Turn this setting off for lower elevations.
■ Standby Mode
Select Communication On to enable the projector to be
monitored and controlled from a computer when it is in standby
mode (the power light is orange).
■ USB Type B
Select how you want to use the USB port. Select USB Display to
use the USB port to project computer images. Select
Page
Up/Down
to use the remote control to advance PowerPoint
slides. Select
Wireless Mouse to use the remote control buttons
like a wireless mouse. See page 61 for restrictions and details.
■ Link 21L
Select On to enable the projector to be monitored and controlled
from a computer using Link 21L software and the Epson USB
Communication driver.
note
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).
To Next Page
Loading...
Need help?
General