Setting Up the Projector
27
When you’ve finished making connections, see Chapter 2 for
instructions on displaying and adjusting the image.
When you’re done projecting from your computer, disconnect the
USB cable.
Installing Software
The first time you connect a computer to the projector’s USB port,
you will need to install software from the projector on your computer.
Follow the instructions for your operating system.
Windows 7 and Windows Vista
When you see the Auto Play window, click
Run EMP_UDSE.EXE
.
Follow the instructions on the screen to install the Epson USB
Display software.
After the software is installed, you see your computer’s current
desktop displayed by the projector. You can switch the projector to
other image sources using the
Source Search
button on the remote
control or the projector.
Windows XP and Windows 2000
Follow the instructions on the screen to install the Epson USB
Display software.
After the software is installed, you see your computer’s current
desktop displayed by the projector. You can switch the projector to
other image sources using the
Source Search
button on the remote
control or the projector.
Macintosh
The setup folder for USB display is displayed in the Finder.
Double-click the
USB Display Installer
icon and follow the
on-screen instructions to install the software.
After the software is installed, you see your computer’s current
desktop displayed by the projector. You can switch the projector to
other image sources using the
Source Search
button on the remote
control or the projector.
note
If the software screen does
not display automatically,
double-click
Computer
or
My Computer
, then
double-click
EPSON_PJ_UD
.
note
It may take a few minutes
before the computer’s
desktop is displayed by the
projector.
To Next Page
Loading...
Need help?
General