Setting Up the Projector
39
2. Choose
Operation
and press
Enter
.
3. Choose
Direct Power On
and press
Enter
.
4. Highlight
On
and press
Enter
.
5. Press
Menu
to exit. The setting will take effect the next time you
plug the projector into a power outlet.
Shutting Down the Projector
This projector incorporates Instant Off technology. To turn it off, you
can press its Ppower button as described below, unplug it, or turn off
a power switch that supplies power to the projector. You don’t have to
wait for the projector to cool down first.
1. To turn off the projector, press the P power
button on the remote
control or projector.
You see a confirmation message.
(If you don’t want to turn it off,
press any other button.)
2. Press the Ppower button again. The projection lamp turns off
and the projector beeps twice. You can then unplug the power
cord.
If you want to turn the projector on again, make sure the orange
Ppower light is not flashing, then press the Ppower button.
note
Lamp life will vary
depending upon mode
selected, environmental
conditions, and usage.
Turn off this product when
not in use to prolong the life
of the projector.
You can set the projector to
automatically turn off the
lamp and enter “sleep mode”
when it has not received any
signals for 1 to 30 minutes
(see page 63). This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the P power button.
If you are done using the
projector, unplug the power
cord.
To Next Page
Loading...
Need help?
General