Maintaining Your Product 100
Cleaning Your Product
Cleaning the Exterior of the Product
To keep your product operating at its best, clean it thoroughly several times a year by using
the following procedure.
c
Caution:
❏ Never use alcohol or thinner to clean the product. These chemicals can damage the
product.
❏ Take care to prevent water from getting inside the product. If moisture, dirt, or other
matter gets inside of the product, besides affecting print quality, it may cause the electric
circuits to short.
1. Make sure the product is turned off and all the lights are off, and then unplug the power
cord from the electrical outlet.
2. Use a soft, clean cloth to carefully remove any dust or dirt.
If the dirt does not come off, clean it using a soft, clean cloth dampened with a mild
detergent. Then, wipe the outside of the product dry with a dry, soft cloth.
Note:
❏ After cleaning the product, close the disc cover and the stacker 4 tray to protect the product
from dust.
❏ Make sure to clean the filter that is located on the rear of the product at regular intervals. See
the next section.
Cleaning the Interior of the Product
To keep your printouts at their best, clean the inside by using the following procedure.
To Next Page
Loading...
Need help?
General
