Troubleshooting 116
Multiple Disc Feeds
❏ Make sure the disc stack fits under the red line in the stacker.
❏ Make sure none of the discs are damaged.
❏ Remove the stack of discs and make sure the discs are not too thin.
& See “Discs” on page 135.
❏ Remove discs from the stacker and fan them before loading them back.
❏ If only one disc is found when multiple feed error is displayed, disc thickness or
warpage maybe out of standard. Follow the steps below to resolve the multiple disc
feed error and replace discs. If the same error continues to occur, contact your dealer.
1. Open disc cover.
2. Remove the disc from the tray.
3. Remove discs from the input stacker.
4. Insert other discs into the input stacker.
5. Close the disc cover and the job will resume.
Disc Jams
If a disc is left in the drive or printer tray, it will be ejected when you turn off/on the product.
If you cannot remove the disc by restarting the product, follow the procedures below:
❏ If a disc is stuck in the printer tray:
1. Turn off the product and unplug the power cable from the wall outlet.
2. Open the maintenance box cover and pull out the maintenance box.
c
Caution:
❏ Do not tilt the used maintenance box. Otherwise ink may leak.
❏ Do not touch the ink ejection port of the maintenance box or the inside of the box
insertion opening of the product.
To Next Page
Loading...
Need help?
General
