188
Note: The lamp usage timer does not register any hours until you have used the lamp for at least 10
hours. Available settings depend on the current input source.
Setting Options Description
Projector Info Source Displays the name of the port to
which the current input source is
connected
Input Signal Displays the input signal setting
of the current input source
Resolution Displays the resolution of the
current input source
Refresh Rate Displays the refresh rate of the
current input source
Sync Info Displays information that may be
needed by a service technician
Status Displays information about
projector problems that may be
needed by a service technician
Serial Number Displays the projector's serial
number
Lens Type Displays the lens model number
Event ID Displays the Event ID number
corresponding to a specific
projector problem; see the list of
Event ID codes
HDBaseT Signal Quality Displays the image signal
information from the HDBaseT
port
Lamp Info Lamp Hours Displays the number of hours (H)
the lamp has been used in
Normal and ECO Power
Consumption modes; if the
information is displayed in
yellow, obtain a genuine Epson
replacement lamp soon
To Next Page
Loading...
Need help?
General
