209
On/Standby
(power) light
Status light Lamp
light
Temp
light
Filter light Status and solution
Blue Off Off Off Off Standby or network monitoring
and control (When Standby Mode
is set to Communication On.
Flashing blue Off Off Off Off Preparing network monitoring or
shutting down. (Wait for the light
to remain orange before
unplugging the projector.)
Blue Flashing
blue
Off Off Off Cooling down. All buttons are
disabled.
Flashing blue Varies Varies Flashing
orange
Varies High temperature warning. If the
temperature gets too high,
projection will automatically stop.
• Make sure that the vents and air
filter are not clogged with dust
or obstructed by nearby objects.
• Clean or replace the air filter.
Varies Varies Flashing
orange
Varies Varies Installation position warning.
Check the installation angle of the
projector.
Off Flashing
blue
Flashing
orange
Flashing
orange
Off Auto Iris error. Turn off the
projector, unplug it from the
electrical outlet, and contact
Epson for help
Off Flashing
blue
Orange Orange Off Power error (balast) or Lens Shift
error. Turn off the projector,
unplug it from the electrical outlet,
and contact Epson for help
Off Flashing
blue
Flashing
orange
Off Off Internal error. Turn off the
projector, unplug it from the
electrical outlet, and contact
Epson for help.
To Next Page
Loading...
Need help?
General
