Item Parameter Explanation
Margins
Side(Right)
3 to 25 mm (7
*
)
Choose the width of the right margin when media is loaded in the printer.
See the following for more information.
U “Printable area” on page 95
Side(Left)
3 to 25 mm (7
*
)
Choose the width of the left margin when media is loaded in the printer.
See the following for more information.
U “Printable area” on page 95
Margin Between Pa‐
ges
0 to 999 mm (10
*
)
Sets the margin between printed pages.
Width Adjustment
-10 to +10 mm (0
*
)
You can adjust a margin between pages. Even after making adjustments,
the size of the margin may change, depending on the media and usage
environment.
The margin increases when the number is moved in the + direction, and
decreases when the number is moved in the - direction.
U “Printable area” on page 95
Print Start Position
0 to 1000 mm (0
*
)
Adjust this parameter if you want to print from the near center of the
media or if you want to shift the printed area left from the Side(Right)
setting. The value set for the area between the right edge of the media and
Print Start Position is left blank. If a value is selected for Side(Right), an
additional area corresponding to the width selected for Side(Right) is left
blank. See the following for more information.
U “Printable area” on page 95
Skip Wrinkled Media
On
*
Normally, leave this On.
When this is On, if jobs do not print continuously, 200 mm of media is fed
to skip wrinkled parts, and then printing is done. However, in the following
situations, the media is not fed.
❏ When printing continuous jobs.
❏ When Margin Between Pages is set to 0.
Off
Job Connection On
When this is turned On, the next job starts printing without feeding media,
drying, or rewinding between continuous print jobs. There are no
operations between jobs so printing time is that much shorter.
Off
*
SC-F10000 Series User's Guide
Control Panel Menu
153
To Next Page
Loading...
Need help?
General