Item Parameter Explanation
Media Tension 0 to 40 Increase tension if creases appear in the media during printing. The higher
the value, the greater the tension.
Media Suction 0 to 10
When media is waved on the platen, increase the Media Suction. The
higher the value, the greater the suction.
If graininess or out-of-focus characteristics are detected in printing results
obtained using thin or soft media or if the media is not fed normally,
reduce the Media Suction.
Head Movement
Data Width Choose the range in which the print head moves during printing.
Data Width restricts print head movement to the printed area. Restricting
the extent of print head movement increases print speed.
If Printer Full Width is selected, the print head will move the full width of
the largest media supported by the printer. Select this option for more
even print results with less variation.
Printer Full Width
Tension Measure-
ment
Periodically
Select Periodically or Every Page to automatically measure the media
tension and adjust to the optimal media feeding operation, or Off to
disable automatic tension adjustment.
Periodically is recommended in most circumstances.
Selecting Every Page enhances the accuracy of the Tension
Measurement for the optimal adjustment, but the printing time is longer
than when Periodically is selected.
The printer may however be unable to adjust tension appropriately for
some media, resulting in excessive slack or other maladjustments that
cause printing problems, in which case you should select Off. Note,
however, that Off may result in unusually large margin between pages. In
addition, after media has been ended, printing may not stop and the
inside of the printer may become stained. Observe the following
precautions:
❏ Do not print at the end of a roll.
❏ Do not set Media End Check in Printer Setup to Off.
Every Page
Off
Multi-Strike Print-
ing
Off Choose the number of times each line is printed.
To carry out high-density printing using backlight films, increase the
frequency.
2 to 8
Feed Speed
Auto
Auto is recommended in normal circumstances. If this option is set to
Auto, media is fed at the optimal speed depending on the number of
printing passes.
Select Lv1 for media that tends to stick together and for thin media that is
easily creased or torn.
Select Lv2 for faster printing. Note, however, that the feed speed will not
change if the number of passes is large.
Lv1
Lv2
Roll Type
Printable Side Out This option is set according to the setting that you selected when you
loaded the media.
Printable Side In
Restore Settings Yes
If Yes is selected, the setting content of selected media settings are
returned to the default settings.
No
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Using the Control Panel Menu
148
To Next Page
Loading...
Need help?
General