Epson SC-S70600 Series - Page 55

N
Confirm that the left edge of the media passes
within the square of the label on the pre-heater.
c
Important:
Perform Steps 13 to 5 in reverse order and
repeat the loading process if the left edge of the
media is not within the black square of the
label. Do not attempt to reposition the roll
holders while they are inserted in the media.
O
Hold the center of the media and raise the media
loading lever.
P
Pull the media straight to the center of the after
heater.
❏ Do not pull the media with both hands. This
could cause the media to skew or move
around.
❏ The labels on the after heater are not used
when media is loaded. If it is adjusted to
forcefully, the media way move around or
become loose.
Q
Lower the media loading lever to hold the media
in place.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
55