Checking Items and Checking Times
109
D
Raise and remove the heater unit.
E
After loosening the screws by hand as shown in the illustration below, remove both covers.
Note:
Take care when handling the removed heater unit. If it is dropped or bumped, it could cause it to malfunction.
Also, if the heater does get damaged, do not reinstall it in the printer.
c
Caution:
Do not touch any parts immediately after printing except for the cover screws. Because the heater reaches
high temperatures, burns could occur.
Note:
Take care when handling the removed covers. If they are dropped or bumped, they could be damaged.
Also, if the covers do get damaged, do not reinstall them in the printer.
To Next Page
Loading...
Need help?
General
