Troubleshooting
116
Troubleshooting
When an Error is Displayed
If an error occurs in the printer, the error is indicated by a warning buzzer and lights, and an error message is
displayed on the Client PC.
Warning Buzzer and Light Displays
Warning Buzzer and lights indicate the following problems. Carry out solutions according to the problem.
Light Displays Warning Buzzer Problem
What to do
0 light is lit The warning
buzzer sounds
until you start to
clear the error or
press the Paper
type setting
switch.
Operations stopped due to an error occurring, the
printer is recovering from an error, or a service call
error has occurred.
Check the error ID on the Client PC. See the
following section or the online help to solve the
problem.
U “Errors and Solutions” on page 118
Contact a technical representative if a service call
error has occurred.
0 light is lit
Ink status light is lit
When the Ink status light is lit, the amount of ink
remaining in the cartridge has fallen below the
minimum limit, or an error has occurred.
Replace the ink cartridge.
U “Replacing Ink Cartridges” on page 63
0 light is lit
Paper status light is lit
If the Paper status light is on, there is no paper in
the roll paper feeder, or paper is running low.
Load paper in the roll paper feeder with the lit
Paper status light.
U “Replacing Paper” on page 32
To Next Page
Loading...
Need help?
General
