Epson SL-D3000

Troubleshooting
146
What to do after an Emergency Stop
A
If the emergency stop occurred while printing, remove the paper.
U “When the Paper Jams” on page 128
B
Connect the power cable to the AC inlet, and then press the Power switch to turn on the printer (the light
turns on).
U “Starting up the Printer” on page 26
C
Click Pre-operation Check on the Client PC.
U “Starting up the Printer” on page 26
This completes this section.
When the Power Fails
Starting after a Power Failure
Start the printer as normal.
U “Starting up the Printer” on page 26
What to do in a Sudden Power Failure
If a sudden power failure occurs while printing, remove paper from inside the printer.
U “When the Paper Jams” on page 128
Cannot Clear the Problem
Contact a technical representative if you cannot clear a problem after checking the contents of the
"Troubleshooting" section.