Replacing Paper
36
Paper Feed Section
The configuration for the paper feed section of the printer changes depending on the model. Although all models
are equipped with a rear roll paper feeder, only the Dual Roll Model is equipped with a front roll paper feeder. Also,
the type of paper supported and the capacity differs for each type of feeder as shown in the following table.
Notes when Loading Paper
O When using the paper for the first time after purchase, we recommend cutting off approximately 3 ft (1 meter)
before use. Depending on the paper's transportation environment, the print quality may decline for this first
part of the paper.
Replacing Paper in the Rear Roll Paper Feeder
Removing Paper
A
Prepare the following items.
Paper Feed Section Supported Paper Types Available Paper Width
Front roll paper feeder Professional Photo Paper Glossy
Professional Photo Paper Luster
4 to 8 inches
(102 to 203 mm)
Rear roll paper feeder Professional Photo Paper Glossy
Professional Photo Paper Luster
4 to 12 inches
(102 to 305 mm)
Items Explanation
New paper for loading You can load the following genuine Epson paper in the rear roll paper feeder.
Professional Photo Paper Glossy
Professional Photo Paper Luster
A linen or vinyl cloth To avoid soiling the paper, place the Spindle unit on the cloth when loading/removing
the paper.
Gloves Wear gloves to avoid soiling the paper when handling it.
To Next Page
Loading...
Need help?
General
