EPSON Stylus C50/C60/C61/C62 Revision C
Disassembly and Assembly Disassembly 114
4.3.10 Lower housing removal
1. Remove the Upper housing from the printer. (Refer to Section 4.3.1)
2. Remove the CR unit from the printer. (Refer to Section 4.3.3)
3. Remove the ASF unit from the printer. (Refer to Section 4.3.5)
4. Remove the PSB/PSE unit from the printer. (Refer to Section 4.3.6)
5. Remove two screws (C.B.S. SCREW 3x6 F/Zn) for securing the Front frame to the
Main frame.
6. Lift up the left side of the Front frame slightly, and slide the Front frame to the left
side carefully with pulling the left side of the Front frame toward the front side of
the printer.
Figure 4-49. Front frame removal
7. Slide the Paper eject roller to the left side while lifting up the following portion.
Figure 4-50. Paper eject roller sliding procedure
CAUTION
Do not damage the Spur gear 60 when sliding the Front frame to
the left side.
CHECK
PO INT
Return the CR unit to the CR home position before sliding the
Front frame to the left side.
C.B.S. SCREW, 3x6, F/Zn
1
2
Paper eject roller
Step2) Slide it to the left side
Step1) Lift the Paper eject
roller shaft upward