Epson Stylus C62 - Printing Area

EPSON Stylus C50/C60/C61/C62 Revision C
PRODUCT DESCRIPTION SPECIFICATIONS 10
1.2.5 Printing Area
1.2.5.1 Cut sheet
Refer to the following table. As for each margin area, refer to Figure 1-4.
* Bottom margin can be set to 3 mm at minimum when the paper length is
designated with "ESC (S" command). However, the printing quality is not
guaranteed in the area, ranging from 3 mm to 14 mm, from the form lower
end. When the paper length is not designated, the bottom margin must be
wider than 14 mm.
Figure 1-4. Printable area for cut sheet
Table 1-7. Printing area
Paper size
Left margin
(min.)
Right margin
(min.)
Top margin
(min.)
Bottom margin
(min.)
A4 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
Letter 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
B5 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
Legal 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
Statement 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
Executive 3 mm (0.12”) 3 mm (0.12”) 3 mm (0.12”)
14 mm (0.54”) / 3mm
(0.12”) *
Printable area
LM
RM
PW
TM
BM
PL