Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21 Revision E
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 50
Confidential
>> From the previous page.
Epson Stylus T20/T20E/T23/T26/S20/T10/T11/ME 30/
T21/
T24/T27/S21
's Case
1. Put the Head FFC through the Hole of the Main Frame.
(see Figure 4-29 (p.48))
2. Secure it with Rib A, then fold it back.
(see Figure 4-29 (p.48))
3. Put the FFC1 and FFC2 through the Ferrite Core.
4. Connect the Head FFC to CN1, CN3 of the Main Board.
(see “ 4.4.1 Main Board ” (p.40))
5. Secure the FFC and the Ferrite Core with strong tape
(60mm) according to the standard given below.
• Align the top of the Ferrite Core in parallel with the
marking shown below.
• The tape must be attached vertically to the Head FFC.
• The lower end of the tape must be 3-4 mm below the upper
side of the hook hole as shown in the figure.
Figure 4-34. Installing Head FFC (6)
Strong Tape (60mm x 18mm)
Hook hole
3-4mm
Marking
CN1,CN3
Ferrite Core
FFC1
FFC2
To Next Page
Loading...
