Epson STYLUS CX3650

EPSON Stylus CX3500/CX3600/CX3650/CX4500/CX4600 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 84
Printer Status Paper jam Maintenance request Fatal error (Mechanism) Fatal error (System)
Indi-
cations
Power — Blink Blink Fast blink
Error Blink On Blink Fast blink
Ink Off On Blink Fast blink
Memory Card
(only for Stylus
CX4500/CX4600)
1 — Blink Blink Fast blink
2 — Blink Blink Fast blink
3 — Blink Blink Fast blink
7-seg. — “E” blink “E” blink Fast “E” blink
Paper Type
1 — Blink Blink Fast blink
2 — Blink Blink Fast blink
Paper Size
1 — Blink Blink Fast blink
2 — Blink Blink Fast blink
Fit to Page — Blink Blink Fast blink
Card Access — Blink — —
Status monitor 3 message
Fault Occurrence Cause
This error is detected when the PE
Sensor cannot properly detect the paper
bottom edge during feeding of paper.
This error is detected when the Waste
Ink Counter exceeds the preset counter
value.
This error is detected when it is
determined that the printer cannot
operate properly.
(CR error, PF error, etc.)
This error is detected when;
• RAM is abnormal.
• System is operating poorly.
Table 3-3. Error Indications and Fault Occurrence Causes
Note : “–” : Don’t care
Blink : 0.5sec. On + 0.5sec. Off repetition
Blink 2 : 0.2sec. On + 0.2sec. Off + 0.2sec. On + 0.4sec. Off repetition
Blink 3 : Blink on and off along with access to a memory card.
Fast blink : 0.2sec. On + 0.2sec. Off repetition
Slow blink: 2.0sec. On + 2.0sec. Off repetition
Note *1: When the setting is “On”.
*2: After finishing copying, the counter returns to the preset number of copies.