Loading Paper in the Sheet Feeder 11
Loading Paper in the Sheet Feeder
To load paper in the sheet feeder, follow these steps:
1. Make sure the paper support is attached.
2. Place your paper against the right edge of the feeder. Make sure the printable (whiter or
glossier) side of the paper is face up. If you are loading multiple sheets, fan the stack of
paper before loading it to prevent paper jams.
Note: Don’t load paper above the arrow mark inside the left edge guide. Some special
papers can be loaded only one sheet at a time. See your online Reference Guide for
details.
3. Slide the left edge guide against the paper.
4. Open the output tray and extend it.
You should also follow these guidelines:
■ Always load the short edge first, even when you’re printing landscape-oriented pictures.
■ When using special papers, check the paper package for additional instructions. Some
papers require using a support sheet included in the package.
Note: Always keep unused paper in the original package and store it flat to
prevent curling.
Pbasics.book Page 11 Wednesday, April 23, 2003 4:30 PM
To Next Page
Loading...
