Epson Stylus Photo R220 - Page 101

EPSON Stylus Photo R220/R230 Revision A
MAINTENANCE Overview 101
<Lubrication Point>
1. Groove on the right side of the
CR Guide Shaft (The Groove is
for the Fixed Spring, Shaft CR,
Right)
2. Contact point between right
side of the CR Guide Shaft and
the Main Frame
<Lubrication Type>
1. G-63
2. G-63
<Lubrication Amount>
1. Half periphery
2. 3mm x 2 points
<Remarks>
Use a syringe to apply it.
<Lubrication Point>
Contact point between left side of
the CR Guide Shaft and the Main
Frame
<Lubrication Type>
G-63
<Lubrication Amount>
3mm x 2 points
<Remarks>
Use a syringe to apply it.
CR Guide Shaft
1
2
2
CR Guide Shaft
<Lubrication Point>
Contact point between left side of
the CR Guide Shaft and the Fixed
Spring, Shaft CR, Left
<Lubrication Type>
G-63
<Lubrication Amount>
3mm
<Remarks>
Use a syringe to apply it.
<Lubrication Point>
Specified points on the Holder,
Scale, Left in the left figure
<Lubrication Type>
G-63
<Lubrication Amount>
8 points (Adequate dose)
<Remarks>
Use a brush to apply it.
CR Guide Shaft
Holder, Scale, Left
Inside surface of the hole
Both sides that are close to
upper surface
Upper surface Upper surface
Upper surface
Upper surface