Epson Stylus Photo R220 - Page 102

EPSON Stylus Photo R220/R230 Revision A
MAINTENANCE Overview 102
<Lubrication Point>
Specified points on the Holder,
Scale, Right in the left figure
<Lubrication Type>
G-63
<Lubrication Amount>
8 points (Adequate dose)
<Remarks>
Use a brush to apply it.
<Lubrication Point>
The Pulley, Driven Assy.
<Lubrication Type>
G-26
<Lubrication Amount>
1mm x 4 points
<Remarks>
Use a syringe to apply it.
Holder, Scale, Right
Upper surface
Both sides
Both sides
Upper surface
Upper surface
Inside surface of the hole
Pulley, Driven Assy.
<Lubrication Point>
1. Upper surface of curving area
of the Holder, Idle Roller
2. Lower surface of curving area
of the Holder, Idle Roller
<Lubrication Type>
1. G-26
2. G-26
<Lubrication Amount>
1. 2 points (Adequate dose)
2. 2 points (Adequate dose)
<Remarks>
Use a brush to apply it.
<Lubrication Point>
Inside surface of the Guide Plate,
CR
<Lubrication Type>
G-26
<Lubrication Amount>
Home position side:
To the edge of ‘Cover, Guide
Plate, CR’.
Anti-home side:
To about 40mm from the edge.
<Remarks>
Use a syringe to apply it.
1
2
Guide Plate, CR