EPSON Stylus Photo R220/R230 Revision A
TROUBLESHOOTING Unit Level Troubleshooting 23
During operation
-
The leading edge of paper is not sent to
the PF Roller.
Paper Guide,
Upper
1. Check if the Paper Guide, Upper has not detached from
the Main Frame.
1. Reattach the Paper Guide, Upper to the Main
Frame.
* The Carriage Unit can move to the home position even if the Extension Spring, 0.22 has detached or the PE Sensor is not set in the correct position.
However, in the next operation, a Paper Jam Error will be detected since the PE Sensor Lever has been kept in a high signal status.
** There some cases where the jammed paper may damage the Print Head by contacting the surface of the Print Head nozzle when a Paper Jam Error occurs.
Table 1-10. Paper Jam Error Check Points by Phenomenon
Occurrence
Timing
Position of CR
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Paper Guide, Upper
To Next Page
Loading...
