Epson Stylus Photo R220 - Page 28

EPSON Stylus Photo R220/R230 Revision A
TROUBLESHOOTING Unit Level Troubleshooting 28
Table 1-15. Status and Possible Causes of CD/DVD Tray Error
Error Status
LED Indication
STM3 Message
Occurrence
Timing
Carriage Unit
Position
at Power-on
Faulty Unit/Part Name Possible Causes Remedy
CD/DVD Tray
Error
Power : --
Paper : ON
Ink : --
CD/DVD tray not set
correctly
Printing
CDR/DVDR
-
CDR Tray Contact point of the CDR Tray Sensor is cracked.
Refer to
Table 1-16
CDR Sensor
The CDR Tray Sensor is damaged.
The CDR Tray Sensor Cable is broken.
Main Board Elements failure
Table 1-16. CD/DVD Tray Error Check Points by Phenomenon
Occurrence Timing
Position of CR
Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
When printing
CDR/DVDR
-
An error occurs even though the CDR
Tray is set when printing CDR/DVDR.
CDR Tray
1. Check if the contact point of the CDR Tray of the CDR
Tray Sensor is not cracked.
1. Replace the CDR Tray with a new one.
CDR Tray Sensor
1. Check if the CDR Tray Sensor is connected to CN11 on
the Main Board.
2. Check if the CDR Tray Sensor is not damaged.
3. Check if the CDR Tray Sensor Connector Cable is not cut
off.
1. Connect the CDR Tray Sensor to CN11 on
the Main Board.
2. Replace the CDR Tray Sensor with a new
one.
3. Replace the CDR Tray Sensor with a new
one.
Main Board 1. Check if any device on the Main Board is not damaged. 1. Replace the Main Board with a new one.
Contact Point
CDR Tray Sensor