Epson Stylus Photo R220 - Page 67

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 67
 When reinstalling the CR Encoder Sensor Board on the Carriage
Unit
 Check if the CR Encoder Sensor Board is correctly secured.
 Check if the CR Encoder Sensor FFC and the PW Sensor
FFC are correctly connected.
 When reinstalling the PW Sensor Board on the Carriage Unit
 Check if the PW Sensor FFC is correctly connected.
 Check if the PW Sensor Board is correctly secured by the
PW Sensor.
 When reinstalling the Holder, Scale (Left/Right) on the Frame,
Main
 Check if the Slider, Holder, Scale is set.
Figure 2-28. Slider, Holder, Scale Reinstallation
Slider, Holder, Scale
 When reinstalling the Carriage Unit
 Check if the Timing Belt is correctly set to the installing
groove of the Carriage Unit.
 Do not contaminate the Timing Belt with grease.
 Check if the Grounding Plate, Head is correctly installed to
the correct position on the Carriage Unit.
Figure 2-29. Installation Position of the Grounding Plate, Head
 Do not touch the lubrication points of the Frame, Main.
 Do not damage and contaminate the CR Guide Shaft.
Grounding plate, Head
Groove
Timing Belt