Epson Stylus Photo R220 - Page 93

EPSON Stylus Photo R220/R230 Revision A
ADJUSTMENT Adjustment Except Adjustment Program 93
5. Move the Carriage Unit to the left edge of the printer, then set the Thickness
Gauge (1.15mm) on the three left ribs of the Paper Guide, Front.
Figure 3-7. Setting the Thickness Gauge
6. Implement PG Adjustment on the left according to the flowchart in the Figure 3-8.
Figure 3-8. PG Adjustment (Left Side)
7. Remove the Thickness Gauge and move the Carriage Unit to the right edge. Then,
set the Thickness Gauge on the three right ribs of the Paper Guide, Front.
Figure 3-9. Setting the Thickness Gauge
8. Implement PG Adjustment on the right according to the flowchart in the Figure
3-10.
Figure 3-10. PG Adjustment (Right Side)
Thickness Gauge
Ribs
Yes
No
Note: Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take up: PG gets wider
Take down: PG gets narrower
Take down the Bushing,
Parallel Adjust, Left toward
the printer front by 1 notch.
Go to Step 7.
Start
Take up the Bushing,
Parallel Adjust, Left toward
the printer back by 1 notch.
Move the Carriage Unit
from side to side on the
Thickness Gauge by using
the Timing Belt.
Does the Thickness
Gauge move?
Yes
No
Move the Carriage Unit
from side to side on the
Thickness Gauge by using
the Timing Belt.
Does the Thickness
Gauge move?
Thickness Gauge
Ribs
Yes
No
Take up:
PG gets wider
Take down: PG
gets narrower
Start
Move the Carriage Unit
from side to side on the
Thickness Gauge by using
the Timing Belt.
Does the Thickness
Gauge move?
Note: Take down toward the printer front by 1 notch:
PG gets narrower.
Take up toward the printer back by 1 notch:
PG gets wider.
Take down the Bushing,
Parallel Adjust, Right toward
the printer front by 1 notch.
Go to Step 9.
Take up the Bushing, Parallel
Adjust, Right toward the
printer back by 1 notch.
Move the Carriage Unit
from side to side on the
Thickness Gauge by using
the Timing Belt.
Does the Thickness
Gauge move?
Yes
No