100 Printing and Scanning Without a Computer
Placing 35 mm Slides on the Film Holder
1. Position the film holder so that the 35 mm slide section faces the center of the
scanner glass. The positioning posts fit in two small holes near the scanner lid,
as shown.
2. Place slides in the film holder as shown, with the duller (emulsion) side
facing up.
Note:
If your slide image is in landscape orientation (wider than it is long), place it in the
same direction as slide images in portrait orientation (longer than they are wide).
This copies the maximum image area, but your preview will be rotated.
Make sure the top of
images with portrait
orientation face the
front of the RX600
sprx600usersguide.book Page 100 Wednesday, February 25, 2004 1:47 PM
To Next Page
Loading...
