Using a Bluetooth Device 125
Connecting the Bluetooth Photo Print Adapter
Make sure the Stylus Photo RX600 is not currently printing. Plug the Bluetooth
Photo Print adapter into the
EXT. I/F USB port on the front of the Stylus Photo
RX600, then fold the front section up or down.
Caution:
Do not connect the Bluetooth Photo Print adapter while the printer is printing. Doing so
may cause the printer to malfunction.
The Bluetooth Photo Print adapter light comes on for one second. If the light does
not turn on, disconnect the adapter from the printer (as described below), then
reconnect it.
Disconnecting the Bluetooth Photo Print
Adapter
Fold the Bluetooth adapter up or down, then pull it out of the EXT. I/F USB port,
as shown below.
Caution:
Do not remove the adapter while it is communicating with another device or while the
printer is printing (while the blue light is flashing). Doing so may cause the printer to
malfunction. Do not remove the adapter by pulling on the upper section or you may
damage the product.
sprx600usersguide.book Page 125 Wednesday, February 25, 2004 1:47 PM
To Next Page
Loading...
