Epson Stylus Photo RX600 - Loading 35 MM Film Strips in the Film Holder

98 Printing and Scanning Without a Computer
3. Continue with one of these sections:
■ “Loading 35 mm Film Strips in the Film Holder” below (for film)
■ “Placing 35 mm Slides on the Film Holder” on page 100 (for slides)
Loading 35 mm Film Strips in the Film Holder
1. Remove the cover for the film strip holder.
2. Slide your film strip into the holder with the duller (emulsion) side facing up.
The top of the images should be facing the outside edge of the film holder and
the images should be reversed.
3. Replace the film cover. (It should snap into place.)
sprx600usersguide.book Page 98 Wednesday, February 25, 2004 1:47 PM