Epson Stylus Photo RX600 - Loading 35 MM Film Strips in the Film Holder

74 Scanning to a Computer
Loading 35 mm Film Strips in the Film Holder
1. Remove the film cover for the film strip holder.
2. Slide your film strip into the holder with the duller (emulsion) side facing up.
The top of the images should be facing the outside edge of the film holder and
the images should be reversed.
3. Replace the film cover. (It should snap into place.)
4. Position the film holder so that the 35 mm film strip faces the center of the
scanner glass. The positioning posts on the film holder fit in two small holes
near the scanner lid, as shown.
Holes
sprx600usersguide.book Page 74 Wednesday, February 25, 2004 1:47 PM