Scanning Film or Slides to a Memory Card 107
Inserting Your Memory Card
1. Make sure your Stylus Photo RX600 is not connected to your computer, or
turn off your computer.
2. Open the memory card slot cover.
3. Make sure the memory card light (next to the card slots) is off and that no
cards are inserted. Then insert a card into the correct slot, as shown.
The memory card light turns green.
Note:
If the card is not properly formatted, you see a message on the RX600 screen.
Press the button indicated on the RX600 screen to format the card. Any data stored
on the card will be erased.
CompactFlash or
Microdrive (bottom) MemoryStick (middle)
SD or MMC (middle)
SmartMedia (top) xD (top)
Memory
card light
sprx600usersguide.book Page 107 Wednesday, February 25, 2004 1:47 PM
To Next Page
Loading...
