Epson Stylus Photo RX600 - Transferring Photos from a Memory Card to Your Computer

114 Printing and Scanning Without a Computer
Cropping Your Selected Photo
1. You see the first cropping screen. Use the u, d, l, and r buttons to move the
top and left guides over the photo to crop the top and left sides.
2. Press the
OK button.
3. You see the second cropping screen. Use the u, d, l, and r buttons to move
the bottom and right guides over the photo to crop the bottom and right
sides.
4. If you have finished choosing the area to crop, press the
OK button.
5. You see a preview of your cropped photo. Press the
OK button. (If you need to
reset the crop area, press the
Cancel button, then repeat steps 1 through 4.)
6. If you want to print multiple copies of your photo, press the u and d buttons
to choose a number to print (1 to 99).
7. Press the x
Color button or x B&W button. Your print job begins printing.
Note:
To cancel a print job while printing, press the y Stop button.
Transferring Photos from a Memory
Card to Your Computer
You can use your RX600 to copy images from a memory card to your computer.
To use this feature with Windows 98 or Me, make sure you’ve installed your Stylus
Photo RX600 software as described on the Start Here sheet (this automatically
installs the necessary USB storage software).
1. Make sure your Stylus Photo RX600 is turned on and connected to your
computer.
2. Insert a memory card as described in “Inserting and Removing Memory
Cards” on page 84. (If you’ll be copying images to the card, make sure the
card’s write-protect tab, if it has one, is set to allow writing to the card.)
sprx600usersguide.book Page 114 Wednesday, February 25, 2004 1:47 PM