32
Note: If you turn off the Paper Size Check setting, printing may occur outside the edges of your
media, causing ink to stain the product. Make sure your print data width does not exceed the loaded
media width.
1 Bottom margin
1
You can configure this margin in the RIP software from 0.2 inch (5 mm) or more; if you set it
below 0.2 inch (5 mm), it is changed to 0.2 inch (5 mm) to maintain feeding accuracy.
2 Top margin
1
You can configure this margin in the RIP software from 0.2 inch (5 mm) or more; if you set it
below 0.2 inch (5 mm), it is changed to 0.2 inch (5 mm) to maintain feeding accuracy. The margin
differs based on how far you pulled the media during loading.
3, 4 Left/Right margins
2
,
3
You select this margin as the Side value of the Roll Paper Margin setting on the product control
panel. The default setting is 0.12 inch (3 mm), but you can select from 0.12 inch (3 mm) or
0.6 inch (15 mm).
To Next Page
Loading...
