116
Removing Jammed Media
If media jams in the printer, check the following:
• Make sure the media is not curled, creased, or folded on the leading edge. Do not use media that
exhibits these problems.
• Check the media specifications to make sure you can use the media with your printer and your RIP
software. Check the RIP software manufacturers media guidelines.
Follow the steps here if media becomes jammed in the product.
1. Turn off the product, wait a moment, and turn it back on.
After a moment, you see a message telling you to open the printer cover on the product control
panel screen.
2. Pull the media toward you and cut off any torn or creased media from the roll using scissors or a
third-party cutting tool.
3. Press the OK button.
To Next Page
Loading...
