54
Maintenance Menu Settings
The Maintenance menu lets you run nozzle checks, cleaning cycles, and other maintenance operations.
You can access the menu by pressing the OK or Menu button while the tab is selected.
Caution: Follow the instructions in the topic links below the table to use these menu settings correctly.
Setting Options Description
Nozzle Check — Prints a nozzle check pattern that you
can visually inspect and then run head
cleaning if necessary.
Head Cleaning
All Nozzles
Selected Nozzles
Execute (Light)
Execute (Medium)
Execute (Heavy)
Lets you clean all or selected nozzles,
based on the nozzle check pattern.
Select the lightest cleaning level first. If
nozzles are still clogged, select a
heavier cleaning.
Cutter Maintenance Adjust Cut Position
Replace Cutter
Adjusts the cutter position in
increments of 0.039 inch (1 mm), from
–0.12 to 0.12 inch (–3 to 3 mm).
Replace Cutter: positions the cutter for
replacement.
Head Maintenance Yes
No
Positions the print head for cleaning
using the head maintenance kit.
Head Cap Cleaning — Positions the print head to allow access
to the caps for cleaning.
Waste Ink Counter — Lets you reset the waste ink counter if
you replace the waste ink bottle before
being prompted by a message on the
control panel.
Parent topic: Using the Control Panel Menus
Related tasks
Replacing the Waste Ink Bottle
Aligning the Print Head
Replacing the Cutter
To Next Page
Loading...
