53
Options Description
Paper Feed Adjust Use this setting if you are unable to resolve banding issues
even after head cleaning and alignment. Select one of the
following:
Pattern: prints an adjustment pattern that you can
measure and then enter the measured distance.
Value: lets you choose an adjustment between –0.70 and
+0.70%. Select a higher value to reduce dark bands, or a
lower value to reduce white bands.
Paper Suction Set from –4 to 0 to increase the gap between the print head
and thin or soft paper. If print quality is reduced or media
does not feed correctly, you may need to lower the suction.
Feeding Tension Set from Lv1 to Lv5. Increase the value if creases appear
in media during printing.
Take-up Tension (if the take-up reel is
installed)
Set from Lv1 to Lv4. Decrease the value if creases appear
in media during printing or ink adheres to the back of the
take-up roll. Increase the value if there is too much slack in
the media or thick media cannot be wound correctly.
Prevent Sticking Select On only if the media sticks to the platen when the
product is turned on or when printing starts. Select Off for
normal printing.
Setting Name Enter a name up to 22 characters for the custom paper
settings.
Restore Settings Select Yes to return all settings for the selected custom
paper to their default values.
Parent topic: Using the Control Panel Menus
Related tasks
Loading Media
Saving Sets of Media Settings
Adjusting the Media Feed
To Next Page
Loading...
