31
8. Press the up or down arrow button to select Setting Name and press the OK button.
9. Press the up or down arrow button to display the letters and symbols you can use to name the media
setting. When you see the desired character, press the right arrow button to move to the next
character position and repeat this step as necessary to complete the setting name. When you finish,
press the back button.
Note: If you need to delete the previous character, press the left arrow button.
10. Press the up or down arrow button as necessary to select each available media setting and press
the OK button. If necessary, press the back button to return to the menu to select additional
settings.
11. Press the pause/cancel button to exit the menus.
Parent topic: Media Handling
Related tasks
Loading Media
Printable Area and Paper Size Checking
The left and right edges of media recognized by your product vary depending on the Paper Size Check
setting.
• When the Paper Size Check setting is turned on, your product automatically detects the left and right
edges of the media.
• When the Paper Size Check setting is turned off, the left edge of the media is determined to be
44 inches (1118 mm) from the standard position for the right edge, no matter the width of the loaded
media. The printable area ranges for the media are described in the table below.
To Next Page
Loading...
