48
5. Make sure the media is taut and confirm that the tension is even by lightly tapping the media on both
sides as shown here.
Note: If the media is looser on one side than the other, the media cannot be taken up correctly.
Repeat these steps to reload the media on the auto take-up reel.
Parent topic: Using the Auto Take-up Reel
Removing Media from the Auto Take-up Reel
After printing on media loaded on auto take-up reel, follow these steps to remove it.
Caution: Remove media from the auto take-up reel with two people, one on each end of the roll.
Removing media by yourself could result in injury.
Note: Make sure the media is cut before removing it from the auto take-up reel.
To Next Page
Loading...
