Epson SureLab D3000 - Double Roll Administrator's Guide

Settings/Maintenance
40
Correction chart color measurement (for the
"i1Pro")
A
Check that the color measurement device you
want to use is connected.
B
Click Measure Color from Correction Value
Creation Phase.
C
Place the color measurement device on the
calibration base plate, and then click OK.
Performs color measurement for the white
calibration tile.
D
Place the correction chart that matches the color
chart ID and preset ID displayed on the screen
on the measurement backup board supplied
with the color measurement device.
Place the chart on white paper if there is no
backup board available for measurement.
E
Click OK.
Color measurement starts.
F
Select Color Measurement Method.
Select a Line Scan to perform color
measurement for each line, or select Spot Scan
to perform color measurement for each patch.
Tip:
For more information on color measurement
device, see the document supplied with the
device.
Tip:
O The color chart ID and preset ID are printed
at the bottom of the correction chart.
O If a correction chart sticks out beyond the
edge of the measurement backup board, cut
off the margin along the cutoff line on the
chart.

Epson SureLab D3000 - Double Roll Specifications

General

Max Print Resolution	1440 x 1440 dpi
Number of Ink Colors	6
Ink Colors	Cyan, Magenta, Yellow, Black, Light Cyan, Light Magenta
Connectivity	USB 2.0, Ethernet
Print Technology	Inkjet
Max Print Size	12 x 48 inches
Print Speed (4x6)	360 prints per hour
Roll Media Width	4", 8", 12"