59
Chapter 2 Setup
2
12
Insert the end of the paper into the paper feed slot. The paper starts to feed
automatically after about 4 cm is inserted.
The Paper LED turns off when the
paper is set properly. If the Paper LED stays on, the paper is not set properly.
Set the paper again.
CAUTION
If the guide panel does not match the paper width, it could cause misaligned printing or paper
jams. Be careful of the following.
Do not allow a gap to occur between the
guide panel and the edge of the paper.
Do not press the guide panel strongly against
the edge of the paper.
To Next Page
Loading...
