Epson tm-m30

75
Chapter 3 Advanced Usage
3
Security
SSL/TLS
You can check and set the SSL/TLS.
• Selection of the server certificate type
(Selfsigned Certificate / CA signed Certificate1 / CA signed Certificate2 / CA signed Certificate3)
• Encryption strength setting (Medium / Low / High)
• Setting for automatic redirect from HTTP to HTTPS (Enable / Disable)
• Confirmation of each certificate
Authentication
Certificate List
You can check the following items for certificates.
• Self-signed certificate setting
• CA signed certificate settings 1 to 3
• CA certificate settings 1 to 10
Certificate Import
This specifies the certificate to be imported.
• File format (PEM / DER Certification / Password Protection PKCS#12 Certificate)
• File name
• Password (If the certificate file format is PKCS#12)
TCP/IP
IP v4 Address
This sets the IP address when setting the manual.
• Setting for IP address acquisition method (Manual / Auto)
• IP address setting
• Subnet mask address setting
• Default gateway address setting
• APIPA setting (Enable / Disable)
• ARP+Ping setting (Enable / Disable)
• IP Address Printing (Enable / Disable)
• Enable the time server when using a certificate.
• If you import and select an invalid certificate, you will no longer be able to start up EpsonNet
Config (Web version). In that case, use EpsonNet Config to select a certificate other than the invalid
one (for example, a Selfsigned Certificate), and import the correct certificate with EpsonNet Config
(Web version) again.