Epson tm-m30

77
Chapter 3 Advanced Usage
3
Bonjour
This sets Bonjour.
• Bonjour setting (Disable / Enable)
• Name input for when using Bonjour*
• Printer name setting for when using Bonjour*
• Installation location input
* You can use upper and lower case alphabet characters, numerals and hyphens, however, only use upper and
lower case alphabet characters for the initial character.
Time Setting
You can check and set the time server.
• Use of time server (Disable / Enable)
• Time server address setting
• Time setting for refresh interval (Can be set between 1 to 10,080 min) - Default is 60 min.
• Confirmation of time server status (Invalid / Success / Synchronize / Failure)
• Error setting
Timeout
This sets the timeout time for printing.
• LPR time-out setting - Default is 90 sec.
• RAW (Port9100) time-out setting - Default is 90 sec.
ePOS-Print
You can check and set ePOS-Print.
• Version confirmation
• ePOS-Print setting (Disable / Enable)
• Device ID setting
• Printer type setting (Thermal(180dpi) / Thermal(203dpi) / Impact / Impact(24pin))
• Setting for character code table type
(Page 0)
(Page 0, 2, 16)
(Page 0-5, 16-19 (GB2312))
(Page 0-5, 16-19)
(Page 0-5, 16-19, 20-21, 26)
(Page 0-5, 16-19, 20-21, 26, 30-31)
(Page 0-5, 16-19, 20-21, 26, 30-31, 11-15, 32-53)