Connecting the Printer to Your Direct Connection Display
Module (For the
TM-U375
only)
Follow the procedures below to connect a direct connection display
module to the printer only when you use the printer as a single unit (not
connected to an intelligent module). When you use the printer with the
intelligent module, refer to the
IT-U Series User’s Manual for details.
1.
Make sure that the printer is turned off.
2.
Plug the cable connector (provided with the direct connection display
module) securely into the printer’s display module connector until it
clicks.
TM-U375
A
CAUTIONS:
1.
Do
not
connect a telephone
line
to the drawer
kick
out
connector.
2.
Do
not
confuse the drawer
kick
out
connector
and
the
display
module connector.
3.
Never connect any
product
other
than the
display
module to the DM connector.
4.
If
you connect
any
product
other than the
display
module to the DM connector,
Seiko
Epson
Corporation
is
not
liable
for
any
damage to the other
product
or to the
TM-U375
itself.
1-10
Setting Up the Printer
To Next Page
Loading...
Need help?
General