Setting the DIP Switches
Turn
off
the printer
while
removing the DIP switch cover
to
prevent
an
electrical short,
which
can damage the
printer.
You can change your interface and print column settings by changing
the
DIP switch settings.
1. Make sure the printer is turned off.
2.
Remove the screw from the DIP switch cover. Then take off the DIP
switch cover, as shown in the illustration below.
3.
There are two sets of switches. Notice that ON is marked on each set of
switches. Use tweezers or another narrow tool to move the switches.
4.
Use the following tables to set the DIP switches. Numbers starting with
1 are in the first set, and numbers starting with 2 are in the second.
1-20
Setting Up the Printer
To Next Page
Loading...
