2.
3.
Check the label on the power supply to make sure that the required
voltage matches that of your electrical outlet.
Plug the power supply’s DC cable connector into the printer’s power
connector as shown below.
TM-U375
TM-U375P
4.
Plug the power supply’s power cord into an electrical outlet.
,
Qh
Note:
To
remove
the DC
cable
connector, grasp
the
connector at the arrow
and pull it
straight
out. Make sure
that
the
power
supply
's
power
cord is unplugged before you disconnect the DC cable connector.
Setting Up the Printer
1-13
To Next Page
Loading...
