Epson UB-E03 - Initializing

Chapter 2 Set up
33
2
Initializing
TheUB‐E03settingcanberesettothedefault,suchaswhencommunicationwiththeUB‐E03is
notpossible.
FollowthestepsbelowtoinitializetheUB‐E03.
1
Turn off the printer.
2
While holding down the Push button, turn on the printer.
Use an extended paper clip or a pen point to push the push button.
3
Keep holding down the Push button until the following message is
printed (about 10 seconds).
4
After about 20 seconds, a message notifying the completion of
socialization is printed.
Afterthecompletionmessage,astatussheetisprinted.
Do not turn off the printer until the initialization is completed.
016(146'.'%1//70+%#6+1075'
-'+06'.'(10#05%*.755/
Push button
4GUGVVKPIVQ(CEVQT[&GHCWNV
2NGCUG9CKV
9#40+0)&1016
67401((219'4
4GUGVVQ(CEVQT[&GHCWNV(KPKUJGF