Epson UB-E03 - Network Parameter of the UB-E03

54
Network Parameter of the UB-E03
ThefollowingtableshowswhetherInitialvalueandRefer/Settingareprintedbyprintingofthe
StatusSheet.
Articles Parameters Initial Value
TMNet
WinConfig
TMNet
WebConfig
Status
Sheet
Refer Setting Refer Setting
IP address - 192.168.192.168 Yes Yes Yes Yes Yes
Subnet mask - 255.255.255.0 Yes Yes Yes Yes Yes
Gateway address - 0.0.0.0 Yes Yes Yes Yes Yes
DHCP Enable/Disable Disable Yes Yes Yes Yes Yes
APIPA Enable/Disable Disable Yes Yes Yes Yes Yes
arp+ping IP setting Enable/Disable Enable Yes Yes Yes Yes No
Community name 1
(read-only)
0-16 characters “public” Yes No Yes No Yes
Community name 2
(read-wirte)
0-16 characters None Yes Yes Yes Yes Yes
IP Trap 1 Enable/Disable Disable Yes Yes Yes Yes No
IP Trap 2 Enable/Disable Disable Yes Yes Yes Yes No
Community name
(IP Trap #1)
0-16 characters None Yes Yes Yes Yes No
Community name
(IP Trap #2)
0-16 characters None Yes Yes Yes Yes No
IP trap #1 address - 0.0.0.0 Yes Yes Yes Yes No
IP trap #2 address - 0.0.0.0 Yes Yes Yes Yes No
Socket Timeout
0: No timeout
1-300: Timeout value (sec)
300 No No Yes Yes Yes
Password - None No Yes No Yes No
Communication
mode setting
Auto Negotiation
10Base-T Half
10Base-T Full
100Base-TX Half
100Base-TX Full
Auto
Negotiation
Yes Yes Yes Yes Yes
Hardware version - 03.xx Yes No Yes No Yes
Firmware version - 01.xx Yes No Yes No Yes
MAC address - 00-26-AB-xx-xx-xx Yes No Yes No Yes