Epson UB-E03 Technical Reference Guide

Chapter 4 UB-E03 Specifications
53
4
•SNMP: SNMP is used to acquire the status and make settings for the module or printer
by custom or general purpose MIB tool.
•ENPC: ENPC is used to acquire the status and make settings for the module or printer.
•TFTP: TFTP is used to update the firmware of the UB-E03. The following methods are
available for the update.
∗ Using the dedicated update utility
∗ Using the TFTP command
Protection with a password
Youcansetapasswordforprotectingthesetcontent.
SNMP Version SNMP v1 (RFC1157) compliant
(SNMP v2 not supported)
Transport Protocol UDP/IP
Server Port Number 161
Trap Sending Port Number 162
Trap Destination Up to two settable IP addresses
Supported MIB type Part of MIB-II (RFC1213), Part of Host Resource MIB,
Part of Print Server MIB, Part of Printer MIB
Supported PDU type Get Request, Get Next Request, Set Request, Get Response,
Trap
Community Each community name can be set with 16 ASCII characters
or less.
Protocol UDP/IP
UDP port number 3289
Compatible packet types Probe, Initialize, Query, Setup, Notify
User Name "epson" (User name cannot be changed.)
Password Default :Undefined
Type of characters settable :ASCII characters
Number of characters settable :Maximum 20
The password set by the EPSON TMNet WebConfig function is used as a password when
setting by using the EPSON TMNet WebConfig.

Epson UB-E03 Specifications

General

Brand	Epson
Model	UB-E03
Category	Control Unit
Language	English